AJA Ki Pro Ultra 12G Installation And Operation Manual page 54

8.0 TC In
This parameter selects the source of timecode from those available.
TC Value (default)
SDI RP188
LTC
TIME OF DAY
8. 1 TC Value
This parameter selects an hour value from which timecode begins incrementing.
00:00:00:00 to 23:00:00:00
(Default: 01:00:00:00)
8.2 TC Type
This parameter selects drop frame or non-drop frame timecode.
NDF (default)
DF
NOTE: If the menu parameter 8.0 TC In is set to SDI RP188 or LTC, the TC Type selection
8.3 Arm Recording
This parameter selects how recording may be initiated, either by pressing the
physical record button (or the web "record" button), or via timecode.
REC KEY (default)
TC/REC KEY
If arm recording on timecode, parameters 8.0, 8.1, and 8.2 must be set to a
qualified source and type of timecode. You should use timecode that starts and
stops, like that produced by record run timecode; freerun timecode is not viable
for this feature since it does not produce start and stop values.
9.0 Interval Record
The Ki Pro Ultra 12G can be used to create time-lapse recordings via the 9.0
Interval Record, 9.1 Interval Frames and 9.2 Interval Time selections.
OFF (default)
ON
Example of time-lapse recording selections:
The incoming video signal is 1080i 29.97 fps, the record button is depressed, and
the recording is then stopped 90 seconds later with the following settings:
• 9.0 Interval Record > On
• 9.1 Interval Frames > 1
• 9.2 Interval Time > Second
The resulting recording would be 90 frames in duration, would have a frame
rate of 29.97 fps, and would appear to be "under cranked" or "sped up" when
compared to a normally created recording.
Ki Pro Ultra 12G File Based Recorder/Player v1.0
does not apply. TC Type only applies to the TC Value or the Time of Day value
generated by the Ki Pro Ultra 12G.
Uses the value specified in parameter 8.1 TC Value
Uses the value from the SDI input
Uses the value from the LTC input
Sets timecode to the device clock value (55.6 Time Set)
Use the User Control Knob to select a timecode hour.
For example: 01:00:00:00, 02:00:00:00, etc.
Selects Non-drop Frame timecode
Selects Drop Frame timecode
Start when Record button is pressed
Start on Time Code or Record button
Normal recordings are produced.
Time-lapse recordings are produced.
54 www.aja.com