AJA Ki Pro Ultra 12G Installation And Operation Manual page 65

To access Ki Pro Ultra 12G, enter its URL in the web browser. The URL will be the
IP address defined in Ki Pro Ultra 12G Network parameter menus (Note that
Config menu parameters 50.1 through 50.4 must all be configured correctly to
access Ki Pro Ultra 12G on your network). If Ki Pro Ultra 12G is using DHCP (the
default), the IP address can be found by going to parameter 50.2 and reading it
there. When Ki Pro Ultra 12G is shipped from the AJA factory, it defaults to DHCP
operation. The DHCP selection is most useful in studio settings where the camera
or cameras may be connected to an existing IT infrastructure.
If 50.1 is set to DHCP, and the DHCP server on the network fails to grant an IP
address, then Ki Pro Ultra 12G 50.2 DHCP Address menu parameter will display
0.0.0.0. No connection to the device can be made with this address. Check with
your network administrator if you experience issues connecting to the device
over a DHCP network.
If 50.1 is set to Default Addr, the factory default static IP address 10.65.74.65 is
used. So, if 50.1 is set to Default Addr, to see Ki Pro Ultra 12G web interface, you
would type the following in the web browser:
http://10.65.74.65
NOTE: Your computer or network must be configured to access this IP address. You may
Figure 13. Default IP Address Configuration
For direct connections between a computer and Ki Pro Ultra 12G, you may
elect to use the Static Addr selection. This allows you to select an IP address for
Ki Pro Ultra 12G and apply it. For example, you could enter 192.168.0.2 as an IP
address. Then, to see Ki Pro Ultra 12G web interface, you would type the following
in the web browser:
http://192.168.0.2
Ki Pro Ultra 12G File Based Recorder/Player v1.0
need to make changes to your network settings on your host computer to access
this IP address.
65 www.aja.com