AJA Ki Pro Ultra 12G Installation And Operation Manual page 12

DISP Button
Use the display button to toggle video overlay display modes. Sequential presses
of the button step through these display modes:
1. No overlay – display is video monitor only
2. Top and bottom status overlay
3. In Multi Channel mode only, smaller audio meter overlays for all current
record channels are shown, along with the top and bottom status overlay
4. A larger headphone audio VU meter overly is shown, along with the top
and bottom status overlay and, if in Multi Channel mode, the smaller record
channel audio meters.
The display button can be used to hide the Config or Status overlay if it is active.
User Control Knob
The User Control Knob on the right side of the Ki Pro Ultra 12G front panel is used
to scroll through and select menu items. After scrolling to, and highlighting a
menu item of interest, push the knob to select. To pop out of a selected menu
item, use the rotator knob to highlight EXIT and push the knob to return to the
top level.
When not in a configuration mode and media is mounted with clips available,
you can use the selection knob to scroll through the clips. Press the knob once to
enable JOG mode to step through the clip a frame at a time.
STATUS Button
When it is not highlighted, you can press the STATUS button to display the status
overlay. Status includes video input, format, record format, and audio setup
information. Once selected, the selector knob can be rotated to display either
the Status or ALARM tab. If any ALARMS or WARNINGS are active, they will be
displayed under the ALARMS tab.
When it is highlighted, pressing the STATUS button hides the Status overlay.
A blinking Status button indicates Alarms are present. Press the STATUS button to
immediately display the ALARM tab.
NOTE: When necessary, you can initiate a "safeboot" of the Ki Pro Ultra 12G by holding in
CONFIG Button
When it is not highlighted, you can press CONFIG to access the Ki Pro Ultra 12G
configuration menu overlay. If the transport is active—video is playing or
being recorded—you will be prompted to stop the transport before entering
configuration mode. Use the User Control Knob to respond to system prompts
by rotating and pushing to select. Once in configuration mode the User Control
Knob can be rotated to scroll the menu system. Push the User Control Knob to
enter a selected menu, scroll through the selections, push to select a setting. To
leave a menu, scroll to Exit and press the knob.
MEDIA Button
When it is not highlighted, you can press the MEDIA button to enter the Media
menu. Pressing MEDIA when it is highlighted will turn Off the Media menu
(returning to the default Transport menu). The Media menu can only be entered
from the transport STOP mode. The Media menu remembers which parameter
it is set to when exited and will return to that same parameter when the menu is
re-entered.
Ki Pro Ultra 12G File Based Recorder/Player v1.0
the STATUS button while powering up.
12 www.aja.com