Data Transfer Via Lan - AJA Ki Pro Ultra Installation & Operation Manual

Data Transfer via LAN

Ki Pro Ultra v1.2r1
Note that for Subordinate Ki Pro Ultra units, the Settings column provides a selection of
either Use: Master Name or Subordinate Name. Clicking on the default value of Master
Name pulls up a pulldown selection of Master Name or Subordinate Name with an OK
confirmation button. If the desire is to have clips named the same across all Ki Pro Ultra
units' recordings, then select Use: Master Name. If the desire is to have clips named
independently on Ki Pro Ultra units, then select Subordinate Name. Selecting
Subordinate Name means that the recording will take it's name from the individual Ki Pro
Ultra's parameters and not accept the value pushed to the Subordinate by the Master Ki
Pro Ultra.
NOTE: Ki Pro Ultra can initiate recordings among units quickly, but not all units will begin or end
recordings precisely at the same time or the same frame. This is not really an issue if matching
timecode via LTC is sent to each unit from a timecode generator via discrete outputs on the
timecode generator or via a distribution amplifier for the timecode.
NOTE: Ki Pro Ultra does not provide simultaneous playback of media; only record start and stop
functions are available.
There are two ways to access Data Transfer mode:
• Use the Ki Pro Ultra front panel UI to set Media State to Data-LAN (see
on page 38).
• Access the Playlist web page and the All Clips mode then click on the media state
toggle icon.
Figure 24. Toggle to Data-LAN Media Transfer Mode
Appropriately encoded QuickTime files may be uploaded to the Ki Pro Ultra or
downloaded from the Ki Pro Ultra.
(For clip encoding requirements, see "Appropriately Encoded Clips" on page
69
"12.1 Media State"
70.)
www.aja.com