AJA Ki Pro Ultra 12G Installation And Operation Manual page 57

41.2 Video SG
This parameter determines the video signal output from Ki Pro Ultra 12G's internal
test signal generator. This parameter is used with parameter 41.1 to determine the
type of video test signal output by Ki Pro Ultra 12G.
OFF (default)
Black
75% Bars
100% Bars
NOTE: The signal generator acts as a "substitute" for the video input. Because of this, if
41.3 Audio SG
This parameter determines the audio signal output from Ki Pro Ultra 12G's internal
test signal generator.
OFF (default)
Silence
1 kHz
50. 1 IP Config
This parameter determines the type of TCP/IP network configuration used by
Ki Pro Ultra 12G.
Static ADDR
DEFAULT ADDR
DHCP (default)
NOTE: With parameters 50.1, 50.2 and 50.3, there is no timeout when editing—changes
Ki Pro Ultra 12G File Based Recorder/Player v1.0
the Video SG is configured for Black, 75% Bars or 100% Bars, you may record these
signal generators as a file. Additionally, if the 41.1 Video SG Frmt parameter is
configured for an RGB format, then the 1.6 SDI Out menu parameter should be set
up for an RGB output if RGB is desired. Note that it is also possible to configure the
SDI Out for YCbCr when the Video SG Frmt is configured for RGB, but a color space
conversion will be applied to the video output.
made while in these menus will be saved and activated when the menu is exited.
Turn test signal output OFF.
Video test signal output is color black.
Video test signal output is 75% color bars. This 75%
amplitude,100% saturation test signal is useful to check low
frequency response and video tilt as well as the performance
of video clamping.
Video test signal output is 100% color bars. This 100% white
full-field bars test signal is helpful to check chroma amplitude
versus overall video level.
Turn audio test signal output OFF.
Output an audio test signal containing silence only.
Output a standard 1 kHz test signal tone.
Assign a static IP address manually (parameters 50.2, 50.3, and
50.4 will have to be entered to accomplish this).
Use the factory default static IP address: 10.65.74.65
Select automatic IP address assignment from DHCP server on
LAN.
NOTE: if Ki Pro Ultra 12G cannot find a DHCP server to
communicate with, it will select the default factory IP address
of 192.168.0.2.
57 www.aja.com