Remote Network Control; Network Connections - AJA Ki Pro Ultra 12G Installation And Operation Manual

Using AC Power
To begin using Ki Pro Ultra 12G, plug the 4-pin XLR on the supplied AC adapter
into the XLR power socket on the rear of Ki Pro Ultra 12G. Then plug the AC
adapter line cord into 110 VAC or 230 VAC (the supply is auto sensing). Two power
supplies can be used for redundancy.
NOTE: When connected to power, Ki Pro Ultra 12G will immediately begin the power-up
Figure 3. Ki Pro Ultra 12G Power Supply Connections
4-pin XLR
Power Sockets
Using DC Power
To run Ki Pro Ultra 12G on DC power, plug a 3rd-party industry standard 12
Volt battery pack with a 4-pin female XLR connector into the power connector
on rear of the Ki Pro Ultra 12G. The battery should be capable of supplying a
sustained max current as supplied by the AC Adapter provided. See
Specifications"
NOTE: To operate Ki Pro Ultra 12G properly, batteries should not have voltage lower than
Ki Pro Ultra 12G is a low-wattage device so many batteries can power it for several
hours at a time. Ki Pro Ultra 12G displays a "Near undervolt" warning prompt to
help you stop recording before battery failure. We also recommend the use of
batteries with metering or remaining power indications. When possible, for very
long recordings, use the supplied AC power supply instead of battery power. Two
power supplies can be used for redundancy

Remote Network Control

Network Connections

Ki Pro Ultra 12G can be networked to a computer using a single CAT-5 Ethernet
cable (straight or cross-over) or using an Ethernet 10/100/1000 local area network
(LAN) connection to the Ethernet RJ-45 connector.
If connecting via a LAN, connect the Ki Pro Ultra 12G Ethernet connector to a LAN
hub or switch. A LAN is a shared network that includes other Ethernet devices all
attached via a hub or digital switch. LANs may be divided into zones, and devices
on a LAN may have fixed or dynamically assigned (DHCP) IP addresses. Before
connecting Ki Pro Ultra 12G to the LAN, talk to your network administrator to find
out how they want it connected (static IP or DHCP).
Ki Pro Ultra 12G File Based Recorder/Player v1.0
procedure. This automatic start-up allows the unit to return to operation as soon
as an unexpected power interruption is corrected.
for more information.
12 volts and should not have voltage that exceeds 18 volts.
DC Supply
20
Line
Cord
"Appendix A
www.aja.com