Table of Contents
Advertisement
Figure 12. Warning Examples
Once there is a Ki Pro Ultra 12G alarm active, the STATUS button light will blink
for as long as the alarm is present. This alerts you so you'll know the reasons for
the alarm condition are still active—you can then check the ALARMS display
by pressing the STATUS button and using the User Control Knob to scroll to the
ALARMS tab.
If you enter the Config or Media menus after an alarm notification, the alarm
display will go away. Pushing any button always returns Ki Pro Ultra 12G to its
pre-alarm state—however, if you are unable to correct the alarm condition after
this initial button push, when you leave these menus, the alarm notification will
reappear on the display.
Ki Pro Ultra 12G features a variety of alarms to help you diagnose the condition of
the unit, possible configuration issues, or possible signal issues.
Warning: Input Format Changed-
and the signal is lost or changed. If this occurs, Ki Pro Ultra 12G stops the
recording that is in progress (unless the Loss of Video Config menu parameter
is set to continue recording.)
Warning: No Video Input -
Ki Pro Ultra 12G. No recording will be performed in this state.
Warning: Input Error -
is supplied to the Ki Pro Ultra 12G or a link of a multi-link signal (dual link or
quad link) is missing; no recordings will be produced if this alarm appears.
Warning: Dropped Frames -
cannot keep up with the data rate required to make a recording or perform a
playback. If you see this prompt during recording, recordings will stop. If this
prompt appears, you might consider backing up your current recordings and
formatting the media. For playback, you might simply re-attempt playback.
Warning: Media Low -
remaining. Media must be switched out when it reaches 10% of capacity. With
10% of media remaining, the "Warning: Media Full" prompt will appear.
Warning: Media in Use -
operation is still taking place. Wait for the operation to finish and then try
again or press STOP.
Warning: Media Not Present -
and the user hits the slot button.
Ki Pro Ultra 12G File Based Recorder/Player v1.0
This prompt appears if a recording is started
May appear if there is no video input to
May appear if a format or frame rate that is not supported
May appear if media is under-performing and
Appears when the media only has 15% of capacity
May appear if you try to use media while another
May appear if media has been physically removed
33
www.aja.com
Hide quick links:
Advertisement
Table of Contents
