Table of Contents
Advertisement
Figure 5. Ki Pro Ultra 12G User Interface Alphanumeric Keypad
Networking Ki Pro Ultra 12G Using the Factory Default IP
If you don't want to use DHCP to network Ki Pro Ultra 12G and also don't want
to set your own static IP address, you can simply use a Default setting to use a
factory setting of 10.65.74.65. This is useful for quickly connecting directly to a
laptop or computer. Here are the steps to set this up:
1. Use the User Control Knob to navigate to parameter "50.1 IP Config", push
the knob to enter the menu, then scroll to select "Default".
2. Set your laptop or desktop computer Ethernet IP address to 10.m.n.m
(where m is not 65 and n is not 74).
3. Also on the computer, set the Subnet mask to 255.0.0.0 (most PCs default
to the proper netmask when the address is set—so you may not have to
change it).
4. Run a browser on the computer and type 10.65.74.65 (the Default factory IP
address). You should now see Ki Pro Ultra 12G' browser status screen.
Controlling Ki Pro Ultra 12G From a Web Browser
To control Ki Pro Ultra 12G from a web browser on a network attached computer,
you must enter Ki Pro Ultra 12G's IP address as a URL in the browser. For example,
if Ki Pro Ultra 12G's IP address were 10.0.6.31, you would then type into the web
browser: http://10.0.6.31
This topic is explained in greater detail in
page 64
Installing Optional SFP I/O Modules
The optional AJA SFP I/O modules are purchased separately from the
Ki Pro Ultra 12G. Install the optional SFP I/O modules by inserting them into
the rectangular cages on the back panel with the electrical connectors
facing downward. Press gently but firmly until the modules seat in the inside
connectors.
Ki Pro Ultra 12G File Based Recorder/Player v1.0
"Chapter 5 Browser Remote Control" on
23
www.aja.com
Hide quick links:
Advertisement
Table of Contents
