AJA Ki Pro Ultra 12G Installation And Operation Manual page 36

The DATA MEDIA STATE does not survive reboots or power cycles of the device.
After such an event, it returns to the default Record-Play mode.
IMPORTANT: When the Ki Pro Ultra 12G is in the Media State and the Data - LAN selection
12.2 Rollover
This parameter determines whether the Ki Pro Ultra 12G is configured to support
recordings that continue when the selected Pak Media becomes full.
OFF (default)
ON
NOTE: Rollover recording is automatically enabled when the Ki Pro Ultra 12G Infinite
Example
A recording is begun on the first piece of Pak Media, S1, and is called "SC1ATK1".
When this piece of Pak Media reaches capacity, the second piece of Pak Media
(S2) is seamlessly engaged and begins an appended recording, "SC1ATK1+1". This
can continue until this piece of media reaches capacity.
IMPORTANT: If a piece of media is inserted for a rollover and it does not meet the
• The rollover media needs to have already been formatted in the
Ki Pro Ultra 12G
• The rollover media needs to be completely empty; no clips can already be on
the media
If the Rollover parameter is set to ON and rollover media does not meet the
criteria noted, warning alarms may appear such as:
• Warning: Media Unformatted
• Warning: Rollover Media Not Empty
NOTE: Pressing the Ki Pro Ultra 12G front panel SLOT button during a rollover recording
12.3 Record Minutes (max)
This parameter specifies the maximum record length of clips. The range is 5
minutes to 240 minutes (4 hrs).
When the max clip time is reached Ki Pro Ultra 12G automatically continues to
record and creates a new clip. The clip naming convention is the same as Rollover
record (appending +n to the file name). During playback, Ki Pro Ultra 12G will play
the clips as if they are one continuous recording. When these clips are imported
into a NLE, they can be seamlessly combined into a single clip without audio or
video drop out.
5 to 240
(default = 240)
Ki Pro Ultra 12G File Based Recorder/Player v1.0
is used, only the web UI for control and configuration of the Ki Pro Ultra 12G may
be used for data transfer. The web UI will present "Upload+" and "Download+"
buttons in the All Clips portion of the UI. If the Data-LAN state is not active, these
buttons do not appear in the web UI.
The Ki Pro Ultra 12G performs recordings normally and do not
When a Ki Pro Ultra 12G recording reaches the 10% of capacity
Record feature is initiated.
following criteria, rollover recordings will not be possible:
forces a change-over to the other Pak Media.
Press Control Knob and scroll up or down to change the Record
continue onto additional media.
"Media Full" point, "appended" files on additional Pak Media
are created for rollover recording.
Minutes (max) value.
36 www.aja.com