Siemens 6SN1123-1AA00-0DA2 Configuration Manual page 8

02.12
05.01
Repairs
!
Proper use
!
Definition:
Who are qualified
personnel?
Objectives
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
Note
Repairs may be performed only by workshops authorized by Siemens who
must use genuine spare parts. Unauthorized repairs and the use of other spare
parts can result in personal injuries and property damage as well as loss of UL
approvals and safety functions, such as Safety Integrated.
Warning
SIMODRIVE converters are used in high voltage installations and are operated
at voltages that when touched can cause serious injuries or death!
Note the following:
Warning
Siemens products may only be used for the intended use in applications
described in the catalog and the associated technical documentation. If
third–party products and components are used, then these must either be
recommended or certified by Siemens. The perfect and safe operation of
products assumes that they have been correctly transported, correctly stored,
located, mounted, installed, commissioned, operated and maintained. The
permissible environmental conditions must be complied with.
Information and instructions in the associated documentation must be
observed.
Setup and operation of the device/equipment/system in question must only be
performed using this documentation. Commissioning and operation of a device/
system may only be performed by qualified personnel. Qualified personnel as
referred to in the safety instructions in this documentation are persons autho-
rized to start up, ground, and label devices, systems, and circuits in accordance
with the relevant safety standards.
This Configuration Manual provides all of the detailed information required to
use and handle SIMODRIVE components.
Should you wish for additional information or should exceptional problems arise
that are not addressed in sufficient detail in this manual, you can request the
required information from your local Siemens office.
The Configuration Manual describes a modular drive system. It is permissible to
use the constellations and general versions described here. All other combina-
tions must be separately and individually released by Siemens.
Forword
vii