Siemens 6SN1123-1AA00-0DA2 Configuration Manual page 31

1 Overview of the Drive System
1.2 Engineering steps
Phase 1 when
engineering
Phase 2 when
engineering
Selecting
cables, cable
protection and
switching devices
1-30
Selecting components
Motor selection
Position sensing
Control units
Power modules
Infeed modules
Line supply connection
Fig. 1-4 Selecting components
Connecting–up
Important
circuit information
Cabinet design and EMC
Block diagrams
Connection diagrams
Dimension drawings
Fig. 1-5 Connecting–up
Cables, cable protection and switching devices must be selected carefully tak-
ing into account the relevant regulations, standards and the requirements of the
location where the system is installed.
Reference: /NCZ/
Reference: /NSK/
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
See Chapter 3
See Chapter 3
See Chapter 4
See Chapter 5
See Chapter 6
See Chapter 7
See Chapter 8
See Chapter 9
See Chapter 4
See Chapter 10
See Chapter 12
Catalog, Connecting System
and System Components
Catalog, Low Voltage
Switchgear
© Siemens AG 2012 All Rights Reserved
02.12
05.01