Siemens 6SN1123-1AA00-0DA2 Configuration Manual page 78

02.12
05.01
SVE pin assign-
ment
S
Table 3-3
1
2
3
4
5
6
7
8
9
S
Table 3-4
1
2
3
4
5
6
7
8
9
10
11
12
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
Encoder signal input (for encoders with current signals) at the signal amplifi-
cation electronics (SVE).
A 9–pin flange–mounted socket with socket contacts for standard round
encoder connectors is provided at the SVE.
The input is located on the side with the PE connection.
Assignment of the SVE signal input
Pin Signal name
AP Current signal input for incremental track A
AN Inverse current signal input for incremental track A
P_ENCODER Encoder power supply
M_ENCODER Encoder power supply ground
BP Current signal input for incremental track B
BN Inverse current signal input for incremental track B
RP Current signal input for track R (zero mark/reference pulse)
RN Inverse current signal input for track R
(zero mark/reference pulse)
SHIELD Ground pin to connect the inner shield
Output of the SVE (connection to the SIMODRIVE controls, input at the
direct measuring system for voltage signals).
A 12–pin flange–mounted socket with plug contacts for standard round en-
coder connectors is provided at the SVE.
Assignment of the SVE signal output
Pin Signal name
BN Inverse voltage signal output for incremental track B
PSENSE Remote Sense encoder power supply (P)
RP Voltage signal input for track R (zero mark/reference pulse)
RN Inverse voltage signal input for track R (zero mark/reference pulse)
AP Voltage signal output for incremental track A
AN Inverse voltage signal output for incremental track A
– not assigned
BP Voltage signal output for incremental track B
– not assigned
MENC Encoder power supply ground
MSENSE Remote Sense encoder power supply (M)
PENC Encoder power supply
3 Motor Selection, Position/Speed Sensing
3.4 Direct position sensing
Function
Function
3
3-77