Siemens 6SN1123-1AA00-0DA2 Configuration Manual page 346

Simodrive 611 series drive converter
Table of Contents

Advertisement

02.12
05.01
For the NC control system
Schematic
diagram
Equipment bus cable
Connection: short–circuit resistant,
cable/busbar
1) The drive group has more than six drive axes. This is the reason that round drive bus cables are used
in the complete group. Further, the shields of those round drive bus cables that are used to jumper/bridge
"Gaps in the module group" must be clamped/connected to the associated module housing!
Fig. 9-7
Connection example, two–tier configuration
Data on the
system design
1. The continuous equipment bus cable of a drive group at one input module or
2. 1500 mm equipment bus extension for a two–tier configuration with a branch
3. The drive bus length may not exceed 11 m.
Note
Connection details for the DC link adapter set, refer to the dimension drawing in
Fig. 12–59.
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
9.1 Installation and connecting–up regulations
Round cable
Cable length, max. 5 m
Terminating connector
for the drive bus
Equipotential bonding cable is routed along
the mounting panel close to the
P600/M600 conductors.
monitoring module may be a maximum of 2.1 m long (from the supply point).
For a two–tier configuration, two equipment bus branches, each with
max. 2.1 m length from the branching point (supply point) can be used at the
infeed.
at the supply/infeed point (Order No.: 6SN1161–1AA00–0AA1).
For more than six modules, control units, round cables must be used
instead of ribbon cables.
9 Cabinet Design and EMC
Adapter terminals, Order No.
For module width, 50 – 200 mm
6SN1161–1AA01–0BA0
For module width, 300 mm
2)
6SN1161–1AA01–0AA0
2) Danger notice!
!
Do not use for module
widths 50 – 200 mm.
Danger of death
because the contact
safety is endangered!
Pay attention to the
cooling!
Length of cable
Twisted, shielded
above 1 m cable length
max 5 m! (in
conjunction with
SIMODRIVE POSMO
SI/CD/CA, the
guidelines correspond
to the User Manual
SIMODRIVE POSMO
SI/CD/CA)
9-345
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents