Agilent Technologies E5052A Programmer's Manual page 71

X-axis Data Arrays
An x-axis data array contains the x-axis values for all measurement points.
The instrument retains the x-axis arrays associated with individual measurements (for the
transient measurement, narrow/wide only). X-axis data arrays are read-only. To retrieve
one of the x-axis data arrays, use the following command:
• :CALC:xx[1-1]:DATA:XDAT
For the transient measurement, you can use two types of command as follows.
:CALCulate:TR[1-1]:NARRow:DATA:XDATa on page 174
•
• :CALCulate:TR[1-1]:WIDE:DATA:XDATa on page 197
Raw Data Arrays
A raw data array contains the measured values just as they were obtained, without any
correction or format applied.
The instrument retains the raw data arrays associated with individual measurements (for
the transient measurement, narrow/wide only). To read/write one of the raw data arrays,
use the following command:
• :CALC:xx[1-1]:DATA:RDAT
For the transient measurement, you can use two types of command as follows:
:CALCulate:TR[1-1]:NARRow:DATA:RDATa on page 174
•
:CALCulate:TR[1-1]:WIDE:DATA:RDATa on page 197
•
There is a raw data array formatted in dBc only when the phase noise measurement is
performed.
:CALCulate:PN[1-1]:DATA:PDATa on page 123
•
4
Reading/Writing Measurement Data
Internal data processing
71