Agilent Technologies E5052A Programmer's Manual page 387

Function
Phase noise Turns on/off the marker list
measurement -
Reads the integrated phase noise, frequency range,
Marker/analysis
RMS noise, RMS jitter, and residual FM of trace
(Continued)
data.
Reads the integrated phase noise, frequency range,
RMS noise, RMS jitter, and residual FM of memory
data.
Phase noise Triggers continuous
measurement -
Triggers once
Measurement
Selects trigger source
Averaging restart
Phase noise
measurement -
Sets/Reads averaging count
Measurement
conditions
Turns on/off averaging function
Sets/Reads the number of correlation
(Not available when option 011 is installed)
Sets/Reads frequency band
Sets/Reads start frequency
(The minimum value is limited down to 10 when
option 011 is installed)
Sets/Reads stop frequency
Sets/Reads IF Gain at 10dB steps
(The value is fixed as 10 when option 011 is
installed)
Sets/readst phase noise Local bandwidth
optimization.
Reads the number of measurement points
Sets/Reads the quality level
Phase noise Sets/Reads the carrier frequency/power data in phase
measurement - noise measurement
Reads/writes the
Sets/Reads the measurement raw data
data
Reads the X data
Sets/Reads formatted trace data
Sets/Reads formatted memory data
Sets/Reads unformatted trace data
Sets/Reads unformatted memory data
7
Setting/Execution item
SCPI Command Reference
Command
:DISP:PN[1-1]:TABL[:STAT]
:CALC:PN[1-1]:TRAC[1-1]:FUNC:INT:DATA
:CALC:PN[1-1]:TRAC[1-1]:FUNC:INT:MEM
:INIT:PN[1-1]:CONT
:INIT:PN[1-1]:IMM
:TRIG:PN[1-1]:SOUR
:SENS:PN[1-1]:AVER:CLE
:SENS:PN[1-1]:AVER:COUN
:SENS:PN[1-1]:AVER:STAT
:SENS:PN[1-1]:CORR:COUN
:SENS:PN[1-1]:FBAN
:SENS:PN[1-1]:FREQ:STAR
:SENS:PN[1-1]:FREQ:STOP
:SENS:PN[1-1]:IFG
:SENS:PN[1-1]:LOB
:SENS:PN[1-1]:SWE:POIN
:SENS:PN[1-1]:SEGT[:MEAS][:QUAL]
:CALC:PN[1-1]:DATA:CARR
:CALC:PN[1-1]:DATA:RDAT
:CALC:PN[1-1]:DATA:XDAT
:CALC:PN[1-1]:TRAC[1-1]:DATA:FDAT
:CALC:PN[1-1]:TRAC[1-1]:DATA:FMEM
:CALC:PN[1-1]:TRAC[1-1]:DATA:UDAT
:CALC:PN[1-1]:TRAC[1-1]:DATA:UMEM
List by function
387