Agilent Technologies E5052A Programmer's Manual page 42

Overview of Remote Control
USB Remote Control System
1. Registering Alias When USB Cable Is Connected
When new device is connected via USB cable, the following dialog box will appear
automatically.Follow the steps below to register alias, when you use the Agilent I/O
Libraries Suite 14.
Step 1. In the Assign USB device alias dialog box, enter an alias and the click the
Figure 2-7 Registering Alias
NOTE
For alias, use the ASCII format less than 127 digits.Alias is upper/lower case insensitive.
If "Never show this dialog" is selected in the "Show this dialog" frame, the dialog box does
not appear even if a new device is connected.
NOTE Once new device is identified, the "New Hardware Search Wizard" will start.Follow the
instruction to implement the processing.
2. Changing Alias on Setting Screen
The following are steps using the Agilent I/O Libraries Suite 14.
Step 1. Step 1: From the Start menu of your PC, click Program - Agilent IO Libraries Suite
-Agilent Connection Expert to open the Config setting screen.
Step 2. In the Config setting screen, select the alias names from
I/O on this PC
menu bar.
42
frame, and then use the
Change Properties
button.
OK
onward in the
USB0 Instrument
from
I/O Configuration
on the
2