Agilent Technologies E5052A Programmer's Manual page 501

Timing Chart and Pulse Width
When the formatted data calculation is completed during the sweep, a negative pulse is
provided. The pulse width of the sweep completion signal is shown in Figure C-3.
Table C-3 Value of T1 in Figure C-3 (typical)
T1
Figure C-3 Pulse width of /SWEEP END
Figure C-4 shows the timing chart for data output and write strobe signal output to ports A
through F.
Table C-4 Values of T1 through T2 in Figure C-4 (typical)
T1
T2
Figure C-4 Timing chart of data output and write strobe signal
C
Communication with External Instruments Using 24-bit I/O Port
Pulse width of /SWEEP END
Response time of write strobe signal
Pulse width of write strobe signal
Timing Chart and Pulse Width
Typical Value
12 μs
1 μs
1 μs
501