Agilent Technologies E5052A Programmer's Manual page 404

SCPI Command Reference
Commands with Variable Parameters and/or Setting Ranges Depending on
Device Configurataion
Table 7-1 SCPI Commands with Variable Parameters and/or Setting Ranges
Command
:SENSe:TR[1-1]:WIDE:FREQuency:MAXimum
:SENSe:UDConverter:HARMonic
:SENSe:UDConverter:LO
:SENSe:UDConverter:MODE
:SENSe:UDConverter:STATe
:SOURce:VOLTage:CONTrol:AFC:FBANd
:SOURce:VOLTage:CONTrol:AFC:INPut:LEVel:MAXimum
:SOURce:VOLTage:CONTrol:AFC:TARGet
:TRIGger:TR[1-1]:NARRow:VIDeo:FREQuency:CENTer
:TRIGger:TR[1-1]:WIDE:VIDeo:FREQuency:CENTer
404
Depending on Device Configuration
Description
Sets/Reads transient frequency range in the wideband
mode
Sets/Reads the frequency offset factor
Sets/Reads the LO frequency of the frequency offset
Sets/Reads the conversion mode of the frequency
offset
Sets/Reads the frequency offset
Sets/Reads the frequency band in the auto frequency
control function
Sets/Reads the maximum input level of the
downconverter in order to determine the IF Gain
Sets/Reads the target frequency
Sets/Reads video trigger frequency value of the
narrowband mode
Sets/Reads video trigger frequency value of the
widewband mode
7