Agilent Technologies E5052A Programmer's Manual page 44

Overview of Remote Control
USB Remote Control System
Control using Agilent VEE
Agilent VEE allows you to control the E5052A via the direct I/O interface.The following
example shows how to control the E5052A to which alias is given as SSA_USBIF.
NOTE When using Agilent VEE for PC, use Agilent VEE Pro 7 for Windows or later version.
Step 1. On the Agilent VEE's
Step 2. In the Instrument Manager setting screen, click
Step 3. The Instrument Properties dialog box appears.Specify Name:
any other name acceptable), Interface:
below, USB port number), and Alias:
the IO Config setting screen), then click
Figure 2-9shows an example of control using the direct I/O interface that has been set in
the above procedures.
44
I/O menu, click Instrument Manager...
Add...
(2 shown below), Board Number :
USB
SSA_USBIF
OK .
.
.
(1 shown below,
SSA_USBIF
(4 shown below which is registered in
(3 shown
0
2