Agilent Technologies E5052A Programmer's Manual page 468

Manual Changes
Manual Changes
Manual Changes
To adapt this manual to your Agilent E5052A, refer to Table A-1 and Table A-2.
Table A-1 Manual Changes by Serial Number
Table A-2 Manual Changes by Firmware Version
Agilent Technologies uses a two-part, ten-character serial number that is stamped on the
serial number plate (Figure A-1). The first five characters are the serial prefix and the last
five digits are the suffix.
Execute the *IDN command on page 274 to check the firmware version.
Figure A-1 Serial Number Plate (Example)
468
Serial Prefix or Number
MY442 or later
Version
A.01.10 or later
A.01.50 or later
A.02.00 or later
Make Manual Changes
Change 4
Make Manual Changes
Change 1
Change 2
Change 3
Appendix A