Image 16-43
6.
Mount the electrical socket. Use an Allen wrench to fasten the two screws.
Caution:
Ensure to orient the electrical socket as illustrated.
Image 16-44
7.
Install the cover of the motor block. Use an Allen wrench to fasten the three screws (reference 1 Image 16-40).
16.16 Replacement of the Inner Dust Rubber
This procedure assumes that the Lens Holder is removed from the projector. See procedure
"Removal of the Lens Holder", page 181.
CAUTION: Be careful as not to damage the inner dust rubber while executing this procedure.
Required tools
•
13 mm nut driver or open-end wrench
•
5.5 mm nut driver or box-end wrench
•
PH1 Phillips screwdriver
Required parts
•
Lens holder cover
•
Dust rubber frame
•
Inner dust rubber
•
6 M3 hex nuts
Lens Holder
R5906848 /04
DP2K SLP Series
195