Barco DP2K SLP Series Service Manual page 349

Code 20103: "LLS – Bank 3 is off"
For this error the same troubleshooting table can be applied to as for code 20101: "LLS – Bank 1 is off".
Code 20104: "LLS – Bank 4 is off"
For this error the same troubleshooting table can be applied to as for code 20101: "LLS – Bank 1 is off".
Code 20105: "LLS – Bank 5 is off"
For this error the same troubleshooting table can be applied to as for code 20101: "LLS – Bank 1 is off".
Code 20106: "LLS – Bank 6 is off"
For this error the same troubleshooting table can be applied to as for code 20101: "LLS – Bank 1 is off".
Code 20107: "LLS – Bank 7 is off"
For this error the same troubleshooting table can be applied to as for code 20101: "LLS – Bank 1 is off".
Code 20108: "LLS – Bank 8 is off"
For this error the same troubleshooting table can be applied to as for code 20101: "LLS – Bank 1 is off".
Code 20109: "LLS – Bank 9 is off"
For this error the same troubleshooting table can be applied to as for code 20101: "LLS – Bank 1 is off".
Code 20128: "LCB – FCB forces lasers off at start-up"
For this error the same troubleshooting table can be applied to as for code 20070: "LCB – FCB forces lasers
off".
Code 20129: "LLS – Phosphor wheel motor speed too low at start-up"
For this error the same troubleshooting table can be applied to as for code 20046: "LCB – Phosphor wheel
motor speed too low".
Code 20131: "LCB – Turn-on LCM 1 failed"
Situation
Light Source cooling could not
be switched on during startup
sequence
Code 20133: "LCB – Turn-on PFC LDM 1 failed"
Situation
PFC (+380 VM / VMA) could
not be switched on during the
startup process of the
projector.
Solution
• Check / reseat the communication cable between the LCB (J600) and
the light source fan interconnection board (J101).
• Upgrade the software to the latest version. See procedure "Software
update via Communicator (DC update companion)", page 249.
• If problem persists, replace the fan interconnection board. See service
procedure "Replacing the Light Source Fan Interconnection Board",
page 72.
Solution
• Check / reseat the power connection to the LDM.
• If problem persists, replace the LDM. See service procedure
"Replacing a Laser Drive Module", page 56.
Troubleshooting
R5906848 /04 DP2K SLP Series 349