Replacement Of The Metal Dust Filters - Barco UDX 4K22 Installation Manual

7. Maintenance
7.3

Replacement of the metal dust filters

C
AUTION
tions of the projector.
W
ARNING
Necessary tools
• Vacuum cleaner
• Compressed air
Necessary parts
Metal air filters
How to replace the small air filter
1. Remove the light processor cover. See "Removal of the left cover", page 91.
2. Locate the metal filter on the inside of the cover.
3. Push both filter holders to the outside and flip the filter out of the holder as illustrated.
Image 7-1
Small metal filter replacement
4. Remove the filter and clean it.
5. Install either the cleaned filter or a new filter (if the old one is no longer usable).
Caution: Take notice of the air flow direction of the filter (made visible by a label). Make sure the arrow points towards the
inside of the projector.
6. Install the light processor cover again. See "Mounting the left cover", page 95.
How to replace the large air filter
1. Remove the small top cover. See "Removal of the small top cover", page 93.
2. Push both filter holders to the outside and flip the filter out of the holder as illustrated.
86
:
The high density filter must be replaced on a regular basis, depending on the environment condi-
:
Switch off the projector and unplug the power cord before starting the procedure.
R5906113 UDX 07/07/2017