Barco DP2K SLP Series Service Manual page 325

Situation
1.80V Supply out of range
2.50V Supply out of range
3.30V Supply out of range
ICP FPGA Temperature out of
range
ICP FMT FPGA Temperature
out of range
ICP Flash Update Error
ICP real time clock error
Satellite Hardware Mismatch
Other possible causes of this error code:
Solution
Replace the ICP board. See service manual chapter "Replacement of the
ICP board", page 214.
Replace the ICP board. See service manual chapter "Replacement of the
ICP board", page 214.
Replace the ICP board. See service manual chapter "Replacement of the
ICP board", page 214.
Temperature on ICP is too high. Current active fans have errors. Solve the
fan problem first.
For a correct airflow, check if all covers are closed.
Ambient temperature is too high. Reduce the ambient temperature.
Temperature on ICP is too high. Current active fans have errors. Solve the
fan problem first.
For a correct airflow, check if all covers are closed.
Ambient temperature is too high. Reduce the ambient temperature.
Replace the ICP board. See service manual chapter "Replacement of the
ICP board", page 214.
1. Clear the error by configuring the RTC (Real Time Clock) of the ICP.
See user manual Communicator chapter "Set up of the ICP clock",
choose the option UTC/GMT time calculated from current PC time
current time.
•
If the error stays:
• replace the RTC (Real Time Clock) battery of the ICP board. See
"Replacement of the RTC battery of the ICP board", page 214.
• Clear the projector error 5800 "ti-icp - system status = fail" with error
message "ICP real time clock error" by configuring the RTC (Real
Time Clock) of the ICP. See user manual Communicator chapter
"Set up of the ICP clock", choose the option UTC/GMT time
calculated from current PC time current time.
• Clear the projector error 5834 "physical marriage tamper event" by
remarrying the projector. See service manual chapter "Authorization
to clear security warning on the projector".
2. If problem remains, replace the ICP board. See "Replacement of the
ICP board", page 214
Replace the Light Processor assembly. See service manual chapter "Light
Processor replacement process", page 97.
Troubleshooting
R5906848 /04 DP2K SLP Series 325