Table of Contents
Advertisement
8 . Series 200a User's Guide
Product Warranty
This product is warranted to be free from defects in material or workmanship under normal use
within the product specifications indicated in this manual and under conditions given below.
This warranty is void if the instrument is not used according to the instruction manual.
The manufacturer makes no warranties, either express or implied, except as provided herein,
including without limitation thereof, warranties as to marketability, merchantability, for a particular
purpose or use, or against infringement of any patent.
No oral or written information or advice given by the manufacturer, its dealers, distributors, agents
or employees shall create a warranty or in any way increase the scope of this warranty.
1. Scope of Warranty:
Any parts that prove to be defective in design or workmanship during the warranty period
will be repaired, adjusted or replaced without charge. A substitute part may be used for
repair, or replacement with an equivalent product may be made instead of repair. Such
system components as a personal computer and printer to be updated frequently for
improvement may not be available in original versions at the time of replacement.
Note that this warranty does not apply to the instrument after it is discarded, or if modified
by the user or resold without permission from the manufacturer, consumable parts, and
any failure of lifetime-expired parts. The manufacturer assumes no liability for any damage
to data or application software due to any possible fault or failure of this instrument.
2. Warranty Period:
One year from the date of initial installation (In case a separate warranty document has
been issued, the warranty period indicated in it takes precedence over the above period)
3. Limitations and Exclusions on Warranty. Note that the following cases are excluded from
the scope of this warranty.
a. Failure due to operation at a place not meeting the installation requirements
specified by the manufacturer.
b. Failure due to power supply voltage/frequency other than specified by the
manufacturer or due to abnormality in power supply.
c. Corrosion or deterioration of the piping due to impurities contained in gas,
compressed air or cooling water supplied by the user.
d. Corrosion of the electric circuits or deterioration of the optical elements due to
highly corrosive atmospheric gas.
e. Failure due to use of software, hardware or spare parts not supplied by the
manufacturer.
f.
Failure due to use not described in the manual or improper repair not approved by
the manufacturer.
Advertisement
Table of Contents
Troubleshooting
