Toshiba TS3000 Series Instruction Manual page 281

series Robot Controller
(b) Step 2: Command selection.
Press [REN].
If you press the ESC key without any character input in the step below, you
can exit this mode.
Press the USB and you can change the file name in the USB drive.
R A M : F I L E
A B C
F I L E 0 0 0 2
F I L E 0 0 1 0
P I C K 0 0 2 4 . P R O
T E S T P R O
N A M E T I M E
(c) Step 3: Input of file name before change.
Select a file name before change, using the cursor, then press the EXE key.
The file name thus selected is displayed on the command line. If it is OK,
press the EXE key. It is also possible to change the file name by deleting
one (1) character by means of the BS key or all characters by means of the
ESC key.
: A B C
(d) Step 4: Input of file name after change.
Select a file name after change.
If you press the ESC key without any character input in the following step, the
system returns to the "input of file name before change" mode.
R A M : F I L E
A B C
F I L E 0 0 0 2
F I L E 0 0 1 0
P I C K 0 0 2 4 . P R O
T E S T P R O
N A M E T I M E
R E N A M E F R O M
1 2 3 4
1 3 2 5
I N P U T
R E N A M E T O
1 2 3 4
1 3 2 5
I N P U T
– 9-9 –
OPERATOR'S MANUAL
( 0 0 1 / 0 2 0 )
2 5 7 F e b - 0 5 - 2 0 0 1
5 6 F e b - 1 3 - 2 0 0 1
M a r - 2 4 - 2 0 0 1
4 5 6 J u n - 1 5 - 2 0 0 1
J u l - 1 2 - 2 0 0 1
( 0 0 1 / 0 2 0 )
2 5 7 F e b - 0 5 - 2 0 0 1
5 6 F e b - 1 3 - 2 0 0 1
M a r - 2 4 - 2 0 0 1
4 5 6 J u n - 1 5 - 2 0 0 1
J u l - 1 2 - 2 0 0 1
U S B
STE 80730