Toshiba TS3000 Series Instruction Manual page 136

series Robot Controller
Operations of each menu are shown below.
Menu
[SAVE] Used to save a data and quit the data editor.
[PRG] Used to select the program editor display. If the data editor was
started up from the basic menu, however, the display will not
change over.
[PYLD] Used to select the load data editor display.
[WORK] Used to select the position data directory display where you can
edit a position data belonging to a coordinate system indicated by
the main cursor.
[TOOL] Used to specify the tool coordinate system for a coordinate
system indicated by the main cursor, and cancel the designation.
[NOSAV] Used to quit the editor without saving data. All changed data are
aborted.
[FIND] Used to search a coordinate name.
[CUT] Used to select the range select mode.
[PASTE] Used to paste the contents saved in the cut buffer (i.e., data
deleted by the previous cut menu) after a position data indicated
by the main cursor to clear the cut buffer.
Each menu of [SAVE], [NOSAV] and [PRG] is the same as in the position data
directory display mode and is not described in this paragraph.
Descriptions
– 5-48 –
OPERATOR'S MANUAL
STE 80730