Battery Installation; Voltage Inspection; Battery; Removal - KYMCO DOWNTOWN 300i Manual

16
. BATTERY/CHARGING SYSTEM

BATTERY

REMOVAL

The battery is in the battery box below seat.
1. Remove the seat.
2. Remove the met-in box
3. Remove four screws and then the battery
retainer.
4. Pull battery out to expose the terminal
leads
5. Disconnect the negative (-) terminal lead
from the battery first, then disconnect the
positive (+) terminal lead.
6. Remove the battery from the battery box.

BATTERY INSTALLATION

Install in the reverse order of the removal.
＊
When install the battery, first connect
the positive (+) cable and then negative
(-) cable to avoid short circuit.

VOLTAGE INSPECTION

Remove the battery cover.
Measure the battery voltage by using a
commercially available digital multimeter.
Voltage (20ºC/68ºF):
Fully charged: 13.0 ~ 13.2 V
Insufficient charged: < 12.3 V
Screws
(+) Terminal
DOWNTOWN 300i
(-) Terminal
16-4