Cabletron Systems SmartSTACK STS16-20RM Installation And User Manual page 191

•
<VLAN Name>
— The MAC Address used by the IP Protocol Stack for the specified VLAN.
—
•
Known-<port type> Port <nn>
— A known address on port nn. The port number "nn" can be followed by
SRT which means that the address is known as source of frames
that shall be switched using the SRT switching mode. If a BRF is
configured for SRT/SRB mode, a MAC address can be known both as
an SRT address and as an SRB address.
— <port type> can be:
TR—The address is known at the specified Token-Ring port.
ATM—The address is known at the specified ATM port
HSTR—The address is known at the specified High-Speed
Token-Ring port
TS—The address is known at the specified Translational Switch.
Port—In this case "nn" will appear as <box number>/<port number>.
The address is known at a port of another switch in the stack.
•
Unknown
—
address in incoming frames at one or more ports. The switch has, however,
not yet learned the location of the address because the station has not sent
any response frames.
•
Multicast
—
as a destination address in incoming frames at one or more ports.
•
STP Multicast
— The group address used as a destination address in IEEE Spanning Tree
Protocol frames.
—
•
STP Multicast-Cisco
— The group address used as a destination address in Cisco Spanning Tree
Protocol frames.
—
Monitoring the Network from the Console Statistics Menu
Present on all ports of that VLAN.
If the address has occurred as a destination address in
incoming frames at other ports, it will be present in these
ports too.
The address is a unicast address and has occurred as a destination
The address is a group address or a functional address and has occurred
Present on all ports.
Present on all ports.
SmartStack STS16-20RM/STS16-20FRM Token Ring Switches, P/N: 9032957-01
177