Installing The Dimm On 7G4282-41 - Enterasys Matrix 7G4282-41 Hardware Installation Manual

Memory Locations and Replacement Procedures

Installing the DIMM on 7G4282-41

To install a DIMM, refer to Figure
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two
DIMM alignment notches. With the two connector arms spread outward, push the
DIMM down between the connector arms. Then release the two connector arms to
lock the DIMM into place.
Figure B-6
➀
DIMM
➁
Connector fingers
B-6 Mode Switch Bank Settings and Optional Installations
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
Installing the DIMM on 7G4282-41
Â
B‐6 and proceed as follows:
Ã
Á
Â
➂
Connector arms
➃
Alignment notches (2)
À
Ã