Installing The Dimm; B-6 Removing The Existing Dimm - Enterasys Matrix 7H4284-49 Hardware Installation Manual

2. Push the connector arms away from the DIMM, as shown in
the DIMM enough to release it from the connector fingers.
Figure B-6 Removing the Existing DIMM
1 Connector arms
3. Rotate the DIMM upwards, then remove it from the connector fingers.

Installing the DIMM

Caution: Observe all antistatic precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precauciones de seguridad para evitar descargas de electricidad estática.
To install a DIMM, refer to
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two DIMM
alignment notches. With the two connector arms spread outward, push the DIMM down between
the connector arms. Then release the two connector arms to lock the DIMM into place.
À
Â
2 DIMM
Figure B-7 and proceed as follows:
Mode Switch Bank Settings and Optional Installations
Memory Locations and Replacement Procedures
Figure
Á
À
3 Connector fingers
B-6, and simultaneously lift
B-9