About This Guide; Who Should Use This Guide; Module - Enterasys Matrix 7G4282-41 Hardware Installation Manual

This guide provides an overview, installation and troubleshooting instructions, and
specifications for the Enterasys Matrix™ DFE-Platinum 7G4202-60 and
7G4282-41 modules.
For information about the CLI (Command Line Interface) set of commands used to
configure and manage the DFE-Platinum modules, refer to the Enterasys Matrix
DFE-Platinum Series Configuration Guide.
Depending on the firmware version used in the DFE-Platinum module, some features
described in this document may not be supported. Refer to the Release Notes shipped
with the DFE-Platinum module to determine which features are supported.

Who Should Use This Guide

This guide is intended for a network administrator responsible for installing and
setting up the DFE-Platinum modules.
Note: In this guide, the following terms are used:
• DFE refers to Distributed Forwarding Engine series of modules.
• DFE-Platinum module or module refers to the 7G4282-41 and 7G4202-60. If the
information applies to only one of the modules, the module is referred to by its model
number (such as 7G4282-41).
• Network expansion module (NEM) refers to an optional uplink card installed on the
main logic board and accessible through the option slot of the 7G4282-41.
Electrical Hazard: Only qualified personnel should perform installation
procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos
de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes
und qualifiziertes Personal vorgenommen werden.

About This Guide

Important Notice
xv