Enterasys Matrix 7G4282-41 Hardware Installation Manual page 52

Completing the Installation
Logging in with an Administratively-Configured User Account
If the device's default user account settings have been changed, proceed as follows:
1. At the login prompt, enter your administratively‐assigned user name and press
ENTER.
2. At the Password prompt, enter your password and press ENTER.
The notice of authorization and the Matrix prompt displays as shown back in Figure
The DFE‐Platinum module is now ready to be configured. For information about setting
the IP address and configuring Telnet settings for remote access to DFE management,
refer to Chapter 3 in the Enterasys Matrix DFE‐Platinum Series Configuration Guide. The CLI
commands enable you to initially set up and perform more involved management
configurations.
The Enterasys Matrix DFE‐Platinum Series Configuration Guide is available online at:
http://www.enterasys.com/support/manuals
If you require assistance, contact Enterasys Networks using one of the methods described
in "Getting Help" on page xviii.
3-24 Installation
Note: Users with Read-Write (rw) and Read-Only access can use the set password
command to change their own passwords. Administrators with Super User (su) access
can use the set system login command to create and change user accounts, and the set
password command to change any local account password. For information on the set
password and set system login commands, refer to Chapter 3 in the Enterasys Matrix
DFE-Platinum Series Configuration Guide
.
3‐13.