Examples, Module Placement In Matrix E7 Chassis - Enterasys Matrix 7G4282-41 Hardware Installation Manual

Backplane Connections and Installation Rules
Figure 3-2

Examples, Module Placement in Matrix E7 Chassis

Example 1
Shows the chassis fully populated with DFE‐Platinum modules (7xxxxx). These modules
communicate with each other via the FTM2 chassis backplane and act as a single
switching entity with one IP address. The DFE‐Platinum modules are configured using a
Command Line Interface set of commands.
Rule: DFE‐Platinum modules can be installed in any available chassis slot in the Matrix E7
chassis.
Example 2
Shows the chassis fully populated with third generation modules (6x3xx). These modules
can also be installed in any available chassis slot in the Matrix E7 chassis, but operate as
individual modules with separate IP addresses. Each module is configured using Local
Management.
Rule: The 6x3xx modules can be installed in any available chassis slot in the Matrix E7
chassis.
Example 3
Shows chassis slots 1 through 5 populated with first and second generation modules
(6x1xx and 6x2xx). If a 6x1xx or 6x2xx series module is installed in slot 6 or 7, it will
operate in standalone mode (no backplane connectivity). Like the 6x3xx modules, the
6x1xx and 6x2xx modules operate as individual modules with separate IP addresses, and
each one is configured using Local Management.
Rule: The 6x1xx and 6x2xx modules can communicate with each other when they are
installed in chassis slots 1 through 5 in the Matrix E7 chassis. If installed in slot 6 or 7, they
operate in standalone mode.
3-4 Installation
(Figure 3-2, A)
(Figure 3-2, B)
(Figure 3-2, C)