Completing The Installation Of A Dfe-Platinum Module In An Existing System; Matrix Dfe Startup Screen Example (N7 Chassis) - Enterasys Matrix 7G4282-41 Hardware Installation Manual

Figure 3-13
login: admin
Password:
M A T R I X N7
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2003
Chassis Serial Number:
Chassis Firmware Revision: xx.xx.xx
Matrix N7(su)->

Completing the Installation of a DFE-Platinum Module in an Existing System

In an established DFE module system,
• a DFE module is already established as the management module,
• the passwords have already been set for various users,
• the system IP address is set, and
• other system parameters have been set.
When you install a new DFE module into a system with an existing configured user
account, the current system settings in that account are already recognized by the new
DFE module and it will operate accordingly.
If you need to change any settings, you can connect a terminal to the local console port as
described in "Connecting to COM Port for Local Management" on page 3‐15 to access
system management, or use a Telnet connection to access the DFE module system
management as described in Chapter 3 of the Enterasys Matrix DFE‐Platinum Series
Configuration Guide.

Matrix DFE Startup Screen Example (N7 Chassis)

xxxxxxxxxxxx
Enterasys Matrix DFE-Platinum Series Hardware Installation Guide
Completing the Installation
3-23