Connecting An Ibm Pc Or Compatible - Enterasys Matrix 7G4282-41 Hardware Installation Manual

Connecting to COM Port for Local Management
2. Plug the RJ45 connector at the other end of the UTP straight‐through cable
RJ45‐to‐DB9 adapter
3. Connect the RJ45‐to‐DB9 adapter
4. Turn on the PC and configure your VT emulation package with the following
parameters:
5. When these parameters are set, the Local Management password screen will display.
Refer to the appropriate Enterasys Matrix DFE‐Platinum Series Configuration Guide for
further information.
Figure 3-10
➀
UTP straight-through cable with RJ45 connectors
➁
RJ45 COM port
3-16 Installation
➂
Parameter
Mode
Transmit
Bits Parity
Stop Bit

Connecting an IBM PC or Compatible

Ã
.
➂
to the communications port on the IBM PC
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
 ➂
RJ45-to-DB9 PC adapter
➃
IBM PC or compatible device
➀
into an
➃
.
Á