Removing Existing Dram Simm From 7G4202-60 Or 7G4282-41 - Enterasys Matrix 7G4282-41 Hardware Installation Manual

DRAM SIMM Replacement Procedure for 7G4202-60
The DRAM SIMM is considered a field replaceable unit on both the 7G4202‐60 and
7G4282‐41.
Removing the DRAM SIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
To remove the existing DRAM SIMM, proceed as follows:
1. Locate the DRAM SIMM connector on the main PC board. Refer back to Figure
2. Push the connector arms away from the DRAM SIMM, as shown in Figure
enough to release the DRAM SIMM from the connector contacts.
Figure B-7
➀
Connector arms
3. Pull the DRAM SIMM straight up and remove it from the connector contacts.
Installing the DRAM SIMM on 7G4202-60 or 7G4282-41
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
To install a DRAM SIMM, refer to Figure
1. Push the connector arms away from the DRAM SIMM enough to insert the DRAM
SIMM into the connector contacts.

Removing Existing DRAM SIMM from 7G4202-60 or 7G4282-41

À
➁
DRAM SIMM
Enterasys Matrix DFE-Platinum Series Hardware Installation Guide
Memory Locations and Replacement Procedures
7G4282-41
and
Á
Â
À
➂
Connector contacts
B‐8 and proceed as follows:
B‐2.
B‐7,
B-7