Mode Switch Location On 7G4202-60 And 7G4282-41 - Enterasys Matrix 7G4282-41 Hardware Installation Manual

Setting the Mode Switches
Switch definitions and positions are as follows:
• Switches 1 through 6 – For Enterasys Networks use only.
• Switch 7 – Clear Persistent Data. Changing the position of this switch clears Persistent
Data on the next power‐up of the module. All user‐entered parameters, such as the IP
address, module names, etc., are reset to the factory default settings. Once the module
resets, you can either use the factory default settings or reenter your own parameters.
• Switch 8 – Clear Admin Password. Changing the position of this switch clears the
admin password, and restores the factory default password on the next power‐up of
the module. Once the module resets, you can either use the factory default settings or
reenter your own password.
Figure B-1
➀
Mode switch pack (7G4202-60 shown)
B-2 Mode Switch Bank Settings and Optional Installations
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin
password to its factory default setting.

Mode Switch Location on 7G4202-60 and 7G4282-41

À