Enterasys Matrix 7G4282-41 Hardware Installation Manual page 35

Installation
To install the module, refer to Figure
Caution: To prevent damaging the backplane connectors in the following step, take care
that the module slides in straight and properly engages the backplane connectors.
Ensure that the top lever lines up with the desired slot number located on the front panel of
the chassis. Refer to
Precaución: Para evitar que se dañen los conectores del panel posterior en el siguiente
paso, intente deslizar el módulo en forma recta y verifique que se enganche
correctamente en los conectores de panel posterior.
Asegúrese de que la palanca superior esté alineada con respecto al número de ranura
correspondiente ubicado en el panel frontal del chasis. Consulte en
1. Locate the chassis card guides
➂
module will be installed. (In this example, slot 1 is being used.) Make sure the
module locking levers are in the open position
2. Align the module card between the upper and lower card guides of the desired slot
and slide it into the chassis, taking care that the module slides in straight. See Caution
below.
Caution: Due to the amount of force needed to properly seat the module connectors into
the backplane connectors, it is best to apply force to the end of the levers to insert (or
eject) the module. Otherwise, damage could result to the module and chassis.
Precaución: Para colocar los conectores del módulo en los conectores del panel
posterior correctamente es necesario hacer bastante fuerza, por ello, para insertar o quitar
el módulo, se recomienda concentrar la fuerza en el extremo de las palancas. Si no lo
hace, podría dañar el módulo y el chasis.
3. Slide the module into the slot until you can engage the top and bottom locking levers
➄
with the chassis as shown in Figure
Caution: In step 4, do not force the locking levers to the point that they touch the face of
the front panel. Forcing the locking levers to this point could damage the module and
chassis.
Precaución: En el paso 4, tenga cuidado de no llevar las palancas de cierre a un punto
en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo y/o el
chasis.
4. Refer to the Caution note above, then rotate the two levers into the closed position
5. If the chassis in which the module is installed was powered down for the installation,
turn the power supplies on. Check to see that the module CPU LED settles at solid
green after a few minutes. If the LED does not turn solid green, refer to Chapter
troubleshooting details.
Installing Module into Matrix E7 or Matrix N7 Chassis
3‐3 and proceed as follows:
Figure 3-3.
➀
that line up with the slot number
3‐3.
Enterasys Matrix DFE-Platinum Series Hardware Installation Guide
Figure
➁
➄
(top and bottom).
3-3.
in which the
➅
.
4 for
3-7