Connecting To A Vt Series Terminal - Enterasys Matrix 7G4282-41 Hardware Installation Manual

Connecting to a VT Series Terminal

To connect a VT Series terminal to an Enterasys Networks DFE‐Platinum module COM
port (Figure
DB25 female adapter, and proceed as follows:
1. Connect the RJ45 connector at one end of the UTP straight‐through cable
COM port
2. Plug the RJ45 connector at the other end of the UTP straight‐through cable
RJ45‐to‐DB25 female adapter
3. Connect the RJ45‐to‐DB25 adapter
terminal
4. Turn on the terminal and access the Setup Directory. Set the following parameters on
your terminal:
Parameter
Mode
Transmit
Bits Parity
Stop Bit
When these parameters are set, the Local Management password screen will display.
Refer to the Enterasys Matrix DFE‐Platinum Series Configuration Guide for further
information.
3‐11), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐
➁
on the Enterasys Networks module.
➂
➃
.
Enterasys Matrix DFE-Platinum Series Hardware Installation Guide
Connecting to COM Port for Local Management
.
➂
to the port labeled COMM on the VT
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
➀
to the
➀
into the
3-17