Installing The Dimm On 4G4282-41 - Enterasys Matrix DFE-Gold 4G4202-60 Hardware Installation Manual

Installing the DIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
To install a DIMM, refer to Figure
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two
DIMM alignment notches. With the two connector arms spread outward, push the
DIMM down between the connector arms. Then release the two connector arms to
lock the DIMM into place.
Figure B-3

Installing the DIMM on 4G4282-41

➀
DIMM
➁
Connector fingers
B‐3 and proceed as follows:
Ã
Â
Á
➂
Connector arms
➃
Alignment notches (2)
Matrix DFE-Gold Series Modules Hardware Installation Guide B-7
Memory Locations and Replacement Procedures
À
Ã
Â