Direction Of Rotation At Hollow Shaft/Stem: Check - AUMA SAVEx 07.2 Operation Instructions Manual

Commissioning (basic settings)
10.4.1.

Direction of rotation at hollow shaft/stem: check

Check direction of rota-
tion
70
SAVEx 07.2 SAVEx16.2/SARVEx 07.2
Figure 77: Direction of rotation of the hollow shaft/stem for operation in direction
CLOSE ("clockwise closing" version)
[1] Threaded plug
[2] Seal
[3] Hollow shaft
[4] Protective cap for stem protection tube
[5] Stem
[6] Stem protection tube
Valve damage due to incorrect direction of rotation!
If the direction of rotation is wrong, switch off immediately (press STOP).
Eliminate cause, i.e. correct phase sequence for cable set wall bracket.
Repeat test run.
1. Move actuator manually to intermediate position or to sufficient distance from
end position.
2. Depending on the version: Unscrew threaded plug [1] with seal [2], protective
cap [4] or stem protection tube [6].
3. Switch on actuator in direction CLOSE and observe direction of rotation at hollow
shaft [3] or stem [5]:
The direction of rotation is correct if the actuator moves in direction CLOSE
and the hollow shaft in clockwise direction, or the stem moves downward.
4. Correctly fit/screw on threaded plug [1] with seal [2], protective cap [4] for stem
protection tube [6], fasten thread.
SARVEx16.2 Control unit: electronic (MWG)
ACVExC 01.2 Non-Intrusive