Electrical connection
Information
Information
32
SAVEx 07.2
SAVEx16.2/SARVEx 07.2
5.
Connect cables according to order-related wiring diagram.
Figure 27: Connect cables to terminal carrier
[1]
Fitting control cables into spring clamp terminals
[2]
Tightening power terminals
For service purposes, each spring clamp terminal is equipped with a test contact
located above the numbering.
For flexible cables: for screw-type terminals, use wire end sleeves according to DIN
46228. For spring clamp terminals, connection is possible without wire end sleeves.
SARVEx16.2 Control unit: electronic (MWG)
ACVExC 01.2 Non-Intrusive