Exiting Programming Mode; Changing Lock Strike Code - Rosslare AYC-Ex5 Instruction Manual

Exiting Programming Mode

1) Press the "#" key two times within 2 seconds
• You will hear 3 beeps.
• The Door LED will turn off
and the Mode LED will
return to Normal.
2) Wrong entries may reset the controller back to Normal
mode.
3) While in Programming
mode, if no key is pressed for one minute the AYC-Ex5 will exit
Programming mode and return to Normal mode.

Changing Lock Strike Code

The Lock Strike Code is mainly used as a method to quickly test
the Lock Strike Relay during installation.
When the first user is added to the controller, the default Lock
Strike Code will automatically be deleted. Once the code is
programmed again, it will not be deleted with the entry of
additional User Codes.
1) Enter Programming mode.
2) Press "1" to enter Menu 1.
• The Mode LED will turn
red.
3) Enter the new code you wish to set as
Lock Strike Code 1.
4) System returns to Normal
mode.
• You will hear three beeps.
Note:
•
•
•
•
AYC-Ex5 family manual
Lock Strike Code 1 does not work in the Secure Mode.
Wrong entries will return the controller to Normal Mode.
Code 0000 will erase the Lock Strike Code 1.
The factory Default 4-digit Lock Strike code is 2580.
Controller Functionality
Mode/Transmit
Mode/Transmit
Green
Mode/Transmit
1
Mode/Transmit
Red
?
Mode/Transmit
Green
Door/Program
Green
Door/Program
Door/Program
Green
Door/Program
Green
? ? ?
Door/Program
Page 38