Exiting The Programming Mode; Changing The Open Code - Rosslare AC-G4 Series Installation And Programming Manual

Programming
5.2

Exiting the Programming Mode

•
Wrong entries may reset the controller back to Normal
• If no key is pressed for 1 minute, while in Programming mode, the
controller exits Programming mode and returns to Normal mode.
To ex it Programming mode:
1. Press # twice to exit Programming mode at any time.
You hear 3 beeps.
The left LED turns green and the right LED
turns off.
Wrong entries reset the controller back to Normal mode.
While in Programming mode, if no key is pressed for one minute,
the unit exits Programming mode and returns to Normal mode.
5.3

Changing the Open Code

The Open code is mainly used as a method to quickly test the Lock
Strike relay during installation.
For security reasons, when the first user is added to the controller or
the Auxiliary code is changed, the default Open code is automatically
deleted; non-default codes are not be erased automatically.
• Open code does not function in Secure mode.
• For wrong entries, you hear a long beep and the controller returns to
Normal mode.
• Code 0000 erases and deactivate the open code.
• The factory 4-digit default setting for the open code is 2580.
AC-F/G4x Series Installation and Programming Manual
mode.
Green
25