Setting The Lockout Feature - Rosslare AYC-Ex5 Instruction Manual

Setting the Lockout Feature

In case the controller is presented with wrong codes,
consecutively several times the unit goes into lockout mode.
When a lockout occurs, the controller keypad and reader are
locked so no codes can be entered until the set lockout period
expires.
During Lockout, Mode LED is Off, Door LED flashes Red, and the
controller beeps every two seconds.
The default setting for the Lockout Feature is 4000 (Lockout
Disabled)
1) Enter the Programming
Mode.
2) Press 6 to enter Menu 6.
• The Mode LED will flash
green
3) Construct a code using the following
instructions:
S et the number of wrong code
attempts, which will cause Locko
between 0 and 9 attempts.
S ets the Duration of the lockout,
between 00 and 99, the value is
multiplied by ten, resulting in
seconds
AYC-Ex5 family manual
Note:
Using the lockout feature is highly recommended, especially
when selecting to use short PIN code length (4 or 5 digits).
Controller Functionality
Mode/Transmit
Mode/Transmit
Green Green
ut
0-99 0
Door/Program
Green
6
Door/Program
4 ? ? ?
Page 50