Entering The Programming Mode; Exiting The Programming Mode - Rosslare AC-F Series Installation And Programming Manual

Programming
5.1

Entering the Programming Mode

• The controller must be in Normal mode to enter the
programming mode.
• The factory default 4-digit programming code is 1234.
• If a Programming code is not entered within 5 seconds, the
controller returns to Normal mode.
To enter Programming mode:
1. Press # twice.
The left LED turns off and the right LED
turns red.
2. Enter your 4-digit Programming code.
The right LED turns green.
5.2

Exiting the Programming Mode

•
Wrong entries may reset the controller back to Normal
• If no key is pressed for 1 minute, while in Programming mode,
the controller exits Programming mode and returns to Normal
mode.
To exit Programming mode:
1. Press # twice to exit Programming mode at any time.
AC-F/G4x Series Installation and Programming Manual
Red
mode.
33