Figure 9-8
9.5.2 Replacement
1. Carefully insert the board in the proper slot in the card cage, ensuring the
board does not slip out of the left and right card guides.
The component side of the board must face up.
2. Ensure the ejector/injector levers are in the outward position while
sliding the board into the backplane.
See Figure 9-8. The board will not seat fully unless the levers are fully out.
Caution – DO NOT FORCE A BOARD into a slot, this can damage the board
!
and system. The board should insert and seat smoothly. If it binds, remove it,
and inspect the card cage for sign of obstruction. Also inspect the board and
backplane for bent pins or other damage.
Storage Devices
Removing or Installing the Disk Card
9
9-11