Figure 7-4 Removing The Side Panels - Sun Microsystems SPARCserver 1000 Service Manual

7.5 Top Panel
Figure 7-4 Removing the Side Panels
The top panel slides rearward to a release point, then lifts off.
Note – You need not remove the top panel to access any system component or
subassembly.
To remove the top panel:
1. Remove the front panel as described in Section 7.1.
Remove the Popouts
1. Remove the four popouts from the top panel:
a. On the panel, find the location where the two dots are adjacent to each
other: one dot on the popout, one on the top panel. See Figure 7-5.
Internal Access
7
7-5