Figure 9-3 Removing The Tape Drive - Sun Microsystems SPARCserver 1000 Service Manual

9
9.2 Tape Drive
9.2.1 Removal
Tape drive
9-4
The optional tape drive is located on the SCSI tray assembly top left side.
1. Disconnect the power and SCSI-2 cables from the rear of the tape drive.
2. Remove two screws securing the bracket to the tray. Remove the 5 1/4-inch
device bracket from the tray.
See Figure 9-1.
3. Slide the bracket out of the tray from the front.
4. Remove the tape drive from the 5 1/4-inch device bracket.
5. Remove four screws (two on each side) securing the drive to the bracket.
See Figure 9-3.
Figure 9-3 Removing the Tape Drive
6. Slide the tape drive out of the 5 1/4-inch device bracket.
SPARCserver 1000 System Service Manual—June 1996
Drive mounting screws (4)